Converting/Fixing the Primaris Repulsor

I'm pretty excited about this one. When the Repulsor first came out, I can't say I was too thrilled about it. Here's the default model for reference:

It has too many guns, all thrown together on that small turret. There's what, 9 weapons on it? And it's so asymmetrical. It's a bit much, especially for a vehicle that's primarily a transport. In addition, I have two Land Raider Crusaders which have a very unique and recognizable shape and profile, especially iconic for Black Templars:

Notice the assault ramp on the front, the sponsons on the side, gobbins on top. That's a Land Raider.

I was considering including Repulsors in my collections - it's a Land Raider mark after all - but I really wanted to get rid of the turret. And I'm not the first one who's had that idea, although I didn't want to change the rules, just the look.

It finally clicked a few months ago:

• Move the twin Lascannon/Heavy Bolter to sponsons (presumably using Predator sponsons),
• Lower the main turret weapon to where the twin Lascannon/Heavy Bolter used to be,
• Replace the front hull with an assault ramp,
• Hide the stubber(s) somewhere, and go from there.

So I got the Repulsor kit, ordered some Predator sponsons and Land Raider hull bits from Ebay, and put on a new xacto blade to get ready for a lot of cutting.

I started by cutting the front off:

When I tried to try-fit the assault ramp, I saw that it didn't go high enough, so I cut away a bit more. I also cut little slots in the full that snugly accept the two extrusions that are supposed to lift the upper part of the ramp.

Looking good! I intentionally made the assault ramp stand out a little bit so that it's noticeable and more alike to that of a classic Land Raider. I later covered the gaps between the assault ramp and the sides of the hull with some plasticard.

Onto the sponsons. I started doing this using Baal Predator sponsons I had lying around. When I got the actual Predator sponsons in the mail, I noticed that they have a slightly different shell. Oops! So I had to use the Baal Predator sponson frame with normal Predator sponson weapons. I think it looks good because Baal Predator sponson frames have a little outline that I could use to cover up cutting mistakes. Anyway:

Next, to I had to cover the turret hole with something. I cut a round bit of plasticard, glued it in, filled the gap and sanded very carefully and very long, until there's no evidence that I had patched a huge hole. Then I threw a few bits around until it looked adequately busy.

Finally, I magnetized everything and put everything together. This isn't too interesting so I didn't take that many pictures, but here's what I did with the roof:

I had to remove some parts of the inside of the hull to make room for those magnets and their sprue mounts:

And that's it! Here are some other pics of the finished model:

(the small gatling cannon wasn't fully assembled when this pic was taken; I literally forgot to finish it until I looked at what I had on the sprue as I was packing it)

It turned out pretty good I think. I have a Repulsor Executioner kit too, ready for the same sponson treatement, that would hopefully result in a cleaner and more symmetrical turret. But that one will probably not have an assault ramp on the front.

Anyway, hope this inspires some of you. It wasn't too much work and it was a lot of fun. The most difficult part, honestly, was finding Predator sponson bits on Ebay - those things are rare.

Thanks for looking!